Attaching the Presser Foot with Included Adapter

While the attached presser foot holder works for most of the feet that The Machine uses, there is an adapter available for use with certain feet that require special use. Note: The ADAPTER is included with The Machine. SOME of the feet that use the adapter are included. The one shown in this demonstration is NOT included with The Machine and can be purchased separately for use.

Step 1: loosen the screw of the presser foot holder so that the foot holder comes off.

Loosen the screw

Loosen the screw

Next, slide the adapter on to the foot bar. Note from the below picture that the adapter is directional, it can only go on the presser foot bar one way.

Directional install

Directional install

Adapter in place

Adapter in place

For the walking foot, the fork on the right of the foot hooks on to the needle clamp screw-bar. The Walking foot shank gets hooked around the bottom screw on the adapter.

Walking foot installed

Walking foot installed